IOT 제품 > 전자부품
DR2032 베터리 홀더( 바느질 부착용 )
 

DR2032 베터리 홀더( 바느질 부착용 )
Sewable CR2032 Battery Holder
 

Sewable CR2032 Battery Holder

Sewable CR2032 Battery Holder

Sewable CR2032 Battery Holder
 


 
Description

This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other tab is +3 Volts.

This holder is meant to be used with Lithium CR2032 (20mm diameter, 3.2mm thick) sized coin batteries. These are almost always 3V at about 200+ mAh capacity. Lithium coin cells are not rechargeable but they are very easy to find, available at any grocery store.

Inserting the coin is easy, the holder is very sturdy, and it snaps out with a push. Its got a nice flat plastic back that you can easily glue in place for extra mechanical stability.



 

 
Technical Details

Datasheet with measurements

 

이전글
플로라 컬러센서 (고휘도 백색 LED 조명, TCS3472) 2015/06/18
Adafruit Micro USB 리튬이온/리튬폴리모 충전기 Adafruit Micro Lipo - USB LiIon/LiPoly charger 2015/06/18
다음글
네오픽셀 링 - 12픽셀 NeoPixel Ring - 12 x WS2812 5050 RGB LED with Integrated Drivers 2015/06/18
네오픽셀 링 - 16픽셀 NeoPixel Ring - 16 x WS2812 5050 RGB LED with Integrated Drivers 2015/06/18