IOT 제품 > 전자부품
EL 와이어 용 Sound Activated 포켓 인버터 EL Wire 6V Sound Activated Pocket Inverter
 

EL 와이어 용 Sound Activated 포켓 인버터
( EL Wire 6V Sound Activated Pocket Inverter )

EL 와이어 소리 반응하는 포켓 인버터 - EL Wire 6V Sound Activated Pocket Inverter

EL 와이어 소리 반응하는 포켓 인버터 - EL Wire 6V Sound Activated Pocket Inverter

Description

  • A small, portable inverter for EL wire with an audio input! This inverter has a little microphone and will light the connected EL according to the surrounding audio volume. Makes for an easy reactive project.

    This inverter requires 6V input (it works great with our 4xAA battery holder) and it can drive 2-3 meters (7 to 10 feet) of our high-brightness EL wire OR 1 meter (3 feet) of EL tape OR a 10cmx10cm piece of EL panel continuously for about 21 hours (off of 4xAA's).

    There is a switch for selecting steady/sound/off modes - steady is 'always on'. Comes with a single 2.5mm pitch female JST connectors, standard for all the EL wire and tape we carry. There's also two power wires, you'll need to connect these to a 6VDC power source. The white striped wire goes to +6V, the plain black wire goes to ground.

    You can plug any of our EL wire/tape into this inverter directly. To connect a 'raw' piece EL wire to this, you'll want a male connector wire

    The EL inverter requires a 'load' to stabilize itself. Do not run the inverter without at least 2 ft of EL wire attached! Otherwise the inverter can spike and damage itself

    Like all inverters we've used, the 2000 Hz oscillation is slightly audible. To reduce the squeaking, we suggest opening up the case padding it with thick foam tape/weatherstripping. Squirting some hot glue around the capacitors may also help. We managed to get it silent this way.

    Check out our EL TRON bag tutorial for ideas, and our EL wire couch video too!

    Soldering to raw EL wire is a little tricky but luckily we wrote a detailed step-by-step tutorial! The tutorial also covers a lot of information about EL and how it works.



     

Technical Details

Dimensions:
  • Inverter Size: 67mm x 51mm x 22mm (2.6in x 2.0in x 0.9in)
  • JST cable length: approx. 20 cm

Weight: 41.80g

이전글
3X4 버튼 패드 Sealed Membrane 3x4 button pad with sticker 2015/06/18
4X4 버튼 패드 Sealed Membrane 4*4 button pad with sticker 2015/06/18
다음글
레인보우 60mm 8x8 Bi(RG) 컬러 LED메트릭스 60mm square 8*8 LED Matrix - Bi-Color Red/Green 2015/06/19
레인보우 60mm 8x8 RGB 컬러 LED 메트릭스 8x8 RGB LED Dot Matrix - Compatible with Rainbowduino 2015/06/19