IOT 제품 > 라즈베리파이
Adafruit Perma-Proto HAT for Pi Mini Kit - With EEPROM
 

Adafruit Perma-Proto HAT for Pi Mini Kit - With EEPROM
 

Adafruit Perma-Proto HAT for Pi Mini Kit - With EEPROM

Adafruit Perma-Proto HAT for Pi Mini Kit - With EEPROM

Adafruit Perma-Proto HAT for Pi Mini Kit - With EEPROM


 

Description

  •  

    Design your own Pi HAT, attach custom circuitry and otherwise dress your Pi A+, B+, or Pi 2 with this jaunty prototyping HAT kit with EEPROM

    To kick off the Adafruit HAT party, we have this Perma-Proto inspired plug in daughter board. It has a grid of 0.1" prototyping soldering holes for attaching chips, resistors, LED, potentiometers and more. The holes are connected underneath with traces to mimic the solderless breadboards you're familiar. There's also long power strips for +3V, +5V and Ground connections to the Pi. Near the top we break out nearly every pin you could want to connect to the Pi (#26 didnt quite make the cut).

    This is the fancier version of our Perma-Proto HAT. It comes with a printed circuit board and a single 2x20 GPIO Header for Raspberry Pi to put your Perma-Proto on top of your Raspberry Pi (like a nice little hat...) This version comes with a blank 24C32 I2C EEPROM soldered on and connected to the EEDAT/EECLK lines so you cannot 'stack' it with other HATs. However, you can program in the EEPROM to make a self-identifying setup using the Pi Foundations' HAT specs - please note the specifications are still under development.

    You can customize your Perma-Proto setup using a standard 2x20 stacking header or extra tall 2x20 stacking header. You can also swap out the 2x20 header with a slim 2x20 type if you want it to sit closer to the Pi, or an extra tall one if you want it to sit above the USB/Ethernet ports.

    A bit of light soldering is required to attach the header to the PCB but it's easy work.

    This hat is only compatible with the Raspberry Pi A+, B+, or Pi 2! It will not work with the Raspberry Pi Model A or B.

    Our initial version has the +3V and +5V markings in blue, and the GND markings in red, future orders will have these colors swapped to better match a solderless breadboard

     


    Technical Details

    • Header Dimensions: 5mm x 51mm x 12mm / 0.2" x 2" x 0.5"
    • PCB Dimensions: 66mm x 57mm x 2mm / 2.6" x 2.2" x 0.1"

이전글
아두이노 27종 센서 모듈 세트 ( 27 Pcs Sensor Set for Arduino ) 2015/06/25
ADKeyboard Module V2 2015/06/25
다음글
IDC Breakout Helper - 2x20 (40 pin) 2015/06/25
7인치 테블릿 및 소형 디스플레이 거치대 ( Adjustable Bent-Wire Stand - up to 7인치 Tablets and Small Screens ) 2015/06/25