IOT 제품 > 라즈베리파이
Pimoroni PiGlow
 

Pimoroni PiGlow

Pimoroni PiGlow

Pimoroni PiGlow

Pimoroni PiGlow


 

Introduction

  •  

    Get visual feedback from your Pi!

    The PiGlow is a small add on board for the Raspberry Pi that provides 18 individually controllable LEDs. You can use it for all sorts of things! And of course, it fits inside a Pibow!

    There are tons of things you can do with it:

    • Mood lighting / ambiance
    • Showing current system load
    • Notify you of events like mentions in tweets or incoming e-mail
    • Feedback the status of scripts/daemons running on your Pi
    • Works great when VESA mounted to provide a cast against a wall
    • ...and pretty much anything else you can think of!

    This board uses the SN3218 8-bit 18-channel PWM chip to drive 18 surface mount LEDs. Communication is done via I2C over the GPIO header with a bus address of 0x54 (Python example code provided). Each LED can be set to a PWM value of between 0 and 255. Comes fully assembled and ready to rock.

    • 18 LEDs (three each of red, orange, yellow, green, blue, and white)
    • Great to provide feedback if you're running your Pi headless
    • PWM (dimming) control for each channel
    • Fully assembled (no soldering required)
    • Python code to access and control lighting provided

Technical Details

  • Max Dimensions: 36.75mm / 1.44" x 33.64mm / 1.32"

For product support, replacement parts and warranty for Pimoroni products visit the Pimoroni forum or contact Pimoroni directly.



Documents


Python, Scratch, WiringPi 예제 코드

이전글
GPIO Header for RaspberryPi A+/B+/Pi 2 - Tall 2x20 Female Header 2015/11/27
Grove - 블루투스 ( Grove - BLE (dual model) ) 2015/11/26
다음글
라즈베리파이 320X240 2.8인치 감압식 터치 스크린 PiTFT Plus Assembled 320x240 2.8" TFT + Resistive Touchscreen 2015/11/27
EL Escudo Dos 2015/12/03