IOT 제품 > 센서
심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )
 

Gravity 심장박동 측정 센서
( Gravity: Heart Rate Monitor Sensor For Arduino )

 심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )

심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )

심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )

 심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )
 


Introduction
  •   

    The DFRobot heart rate sensor is a thumb-sized heart rate monitor designed for Arduino microcontrollers.

    This sensor is a pulse sensor which is developed based on PPG (PhotoPlethysmoGraphy) techniques. This is a simple and low-cost optical technique that can be used to detect blood volume changing in the microvascular bed of tissues. It is relatively easy to detect the pulsatile component of the cardiac cycle according to this theory.

    The sensor has two holes that you can use to attach to your belt. You can wrap on your finger, wrist, earlobe or other areas where it has contact with skin.

     

    To ease the difficult of using this sensor,  a Gravity Interface is adapted to allow plug&play.  The IO sensor shield is the best match for this sound senor connecting to your Arduino or other microcontroller. As this sensor can work at 3.3V which make it compatible with Raspberry Piintel edison, joule and curie. 

     
    심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )

    심장박동 측정 센서 ( Gravity: Heart Rate Monitor Sensor For Arduino )

    NOTE: 
    1. This product is NOT a professional medical device and should not be used to diagnose or treat medical conditions. 
    2. This sensor is designed to work when the user is not moving. If used while moving it will give inaccurate results.

     




Specification

  • Input Voltage (Vin): 3.3 - 6V (5V recommended)
  • Output Voltage: 0 - Vin (Analog), 0/ Vin (Digital)
  • Operating current: <10mA
  • Dimension: 28 x 24(mm), 1.102" x 0.945"(in)
  • Interface Type: PH2.0-3P

 

Document



 


Shipping List

  • Heart Rate Monitor Sensor For Arduino x1
  • Wrist belt x1
  • PH2.0-3P cable x1

이전글
Gravity 아두이노용 아날로그 적외선 CO2 센서 ( Gravity: Analog Infrared CO2 Sensor For Arduino 0~5000 ppm ) 2016/11/17
아두이노용 TCS34725 RGB 컬러 센서 ( TCS34725 RGB Color Sensor For Arduino ) 2016/11/17
다음글
DFRobot CurieNano - A mini Genuino/Arduino 101 Board 2017/01/16
아두이노 101/ 제누이노 스타터 키트 ( Gravity: Starter Kit for Genuino / Arduino 101 with Tutorials ) 2017/04/25